Table of Contents
Advertisement
APPENDIX 4
IMPORTANT NOTES ABOUT INSTALLING THE FMX008 YOURSELF
You may install your FMX008 yourself if you wish as it is easy enough if you are careful.
However, please note that the following problems could be had.
•
ALWAYS disconnect the S3000XL's mains lead from the mains outlet when opening
the S3000XL's casework.
•
Unless you have disconnected the S3000XL's mains lead from the mains outlet, you
run the risk of an electric shock which could be fatal.
•
Unless you have disconnected the S3000XL's mains lead from the mains outlet, you
run the risk of damaging the FMX008, the S3000XL or any other equipment that may
be connected to the S3000XL.
•
Depending on your environment, your body could have a high static electricity charge
which, when you handle the FMX008 board, could destroy the memory chips on it
and/or cause damage to the S3000XL's circuitry. To minimise static electricity, avoid
carpeted areas and low humidity areas.
•
If the board is inserted incorrectly and/or damaged, this could cause long term (and
expensive) damage to the FMX008 board and/or your sampler.
•
Incorrect installation will invalidate any warranty on the FMX008 and the S3000XL.
•
Akai Electric Co. cannot be held responsible for any damage to the FMX008 board,
the S3000XL and/or any peripheral equipment (disk drives, mixers, amplifiers,
recording equipment, etc.) that may be damaged as a result of incorrect installation of
the FXMoo8.
•
Akai Electric Co. cannot be held responsible for any loss of earnings, income or
damage to your personal or professional reputation through incorrect installation of
the FXMoo8. Neither can Akai Electric Co. be held responsible for loss of employment
opportunities as a result of incorrect installation of the FMX008.
•
Akai Electric Co. cannot be held responsible for any physical harm that may come to
you as a result of installing the FXM008 yourself and/or as a result of incorrect
installation of the FXMoo8.
You should be able to install the board yourself providing you observe the precautions
and indemnities very carefully and you proceed with caution and take care and use
common sense.
However, if you have even the slightest bit of doubt regarding installing the FXM008
yourself, please consult your Akai dealer who will be able to install the board for you.
Although this may incur a small charge, this is preferable to the consequences that may
result from incorrectly installing it yourself.
Page 300
S3000XL Operator's Manual
Advertisement
Table of Contents
