Table of Contents
Advertisement
GLOBAL
MAKING A RECORDING
To prepare for a recording, press
screen display:
This is the disk record set-up page and here you may select and create takes to record as
well as set their record parameters. The fields are:
Page 252
This shows the currently selected take. To select another, you can either
scroll through the takes on disk using the DATA control or type in their
names from the front panel by pressing the NAME key, typing in the name
and then pressing ENT. You may also create new takes for recording in
the same way but by entering a unique take name.
This selects whether the recording will be in mono or in stereo.
This selects the input for the recording - whether it will be through the
analogue inputs on the front panel or via the digital audio interface. The
selection choices are ANALOG or DIGITAL.
This selects the method by which recording will commence. The options
are:
- This will cause recording to commence once a certain
threshold level has been exceeded. The threshold level is set in the TAKE
page (see below).
- This selects that a MIDI NOTE will initiate recording. The MIDI
note number is set in the NOTE field described below.
- This selects that recording will start when it receives a MIDI
note but with an offset as set in the DELAY field described below. The
MIDI note number is set in the NOTE field described below.
- This selects that a MIDI SONG START command will initiate
recording.
This allows you to set an offset for the MIDI note reception when
is selected in the
This allows you to route the take to one of the four effects channels FX1,
FX2, RV3 or RV4 if the optional EB16 effects board is installed.
This allows you to set the send level of the take to the effects channel
selected in the
in any of the DD pages. You will receive this
field.
field.
S3000XL Operator's Manual
Advertisement
Table of Contents
