Akai S3000XL User Manual page 136

EDIT SAMPLE
Moving the cursor to the
As with the
and -/> keys found on the numeric keypad. Running across the top of the waveform
display you will see up to four horizontal lines which show you where you have set your
loop point(s). Up to four may be shown simultaneously - the top one is LOOP 1, the
second one down is LOOP 2, the next one down LOOP3 and the bottom one is LOOP 4.
I.e:
The loop points cannot be edited in the TRIM page but these will give you a clearer
indication of where you are when setting start and end points for trimming. If you move
the start or end points into a loop, you will see this screen:
A similar screen would be shown if you were to move the end point into a loop. The
warning will be shown temporarily and you should move the start (or end) point out of the
loop.
Once you have set the start and end points, press F8 -
audio either side of the start and end point. You will receive this screen display:
Page 130
field and adjusting that will give you a display such as:
field, you may move the cursor around the numeric field using the +/<
LOOP1 LOOP2 LOOP3 LOOP4
- to discard the unwanted
S3000XL Operator's Manual