Icom ID-RP2 Service Manual page 61

SECTION 3
• REMOVING THE COVER
1 Unscrew 12 screws A, and remove the cover B.
2 Disconnect the cable C, and disconnect the cable D.
A
A
D
CHASSIS unit
•
REMOVING THE LOGIC-D UNIT
1 Unscrew 1 screw A, and remove the cover B.
2 Remove 2 main shield plates C.
3 Disconnect 2 cables D, and unsolder 1 point E.
4 Unscrew 4 screws F, and remove the earth spring G.
5 Take off the LOGIC-D unit.
F
G
C
D
LOGIC-D unit
DISASSEMBLY INSTRUCTIONS
B
A
A
C
A B
C
E
F
D
D - 3 - 1
•
REMOVING THE MAIN-D UNIT
1 Unsolder 5 points A, and remove the ANT plate B.
2 Unsolder 12 points C.
3 Unscrew 2 screws D, and remove the ANT connector E.
4 Take off the cable F from the chassis.
5 Disconnect the cable G.
6 Unscrew 7 screws H, and take off the MAIN-D unit.
F
D
E
H
G
B
A
A
H
H
C
MAIN-D unit