Table of Contents
Advertisement
System Options
The system options button allows for limited modification of setup of the codec. Modification of
these setting from the default values may affect the operation of the Director system. The main
item of note is the Camera Model setting. The system supports VISCA controlled cameras and can
therefore is selectable between the WAVE and VISCA controlled cameras. VISCA cameras would
use the Aux 1 Output on the Director Rear Interface Panel.
Edit Directory
To edit the system directory directly, follow the instructions detailed in the Director Module User's
Guide.
Updating the Directory
If installing a codec with directory entries existing on it, or if any of the directories have be
modified through any other method than using the Edit Directory method discussed above (i.e.
Codec Data port, Web browser, Telnet, or TMS), you must edit the
Codec Configuration
The control system communicates with the codec through Data 1 at 9600 baud, No parity bit, 8
data bits, and 1 stop bit. The codec should be left in it's default configuration with the following
exceptions. Using the remote control, or the IR functions in the Setup Page, the following settings
should be changed.
Input codec software option keys
All network and LAN information (SPIDS, IP Addresses, etc. )
Autoanswer On (or On + Mic off)
Dual Monitor On
19
19
19
19
Advertisement
Table of Contents
