Pc Sources; Powering On The System - TANDBERG Director Installation Manual

Codec software version b5, control software version v1

Hide thumbs Also See for Director:

Table of Contents

PC Sources

The Main and Secondary PC's connect to the X-port 10 Switcher. The Internal PC's audio,

control, and VGA connects internal to the 3000i cabinet with the cables provided. The Secondary,

or laptop pc should be connected to the external cable loom provided. These connections to the

X-port 10 allow for the first PC to be shown, but can switch to the second PC source when a

video signal is detected.

Once cabling has been completed, the system is now ready for the AC mains to be plugged in. To

verify that all components have been powered on, you should be able to see the following LED

indicators through the smoked glass cover.

If any of the green or red LED's do not show through the smoked glass, the system will not work

properly. Contact TANDBERG Technical Service immediately.

To power on the projector, press the green Projector Standby Button on the front of the 3000i

cabinet. Once powered, refer to the 3000i User's Manual to adjust the image to fit the screen.

LED Indicator of Lamp Status

Projector Standby Button

Table of Contents