Assembly And Installation Instructions - TANDBERG Director Installation Manual

Assembly and Installation Instructions

1. Read the "Installation Considerations" on page 23 and proceed after all considerations
have been understood and satisfied.
2. Read the guidelines for "Selecting a Mounting Location" on page 24 and select a
mounting location.
3. Determine if the ceiling tracks are 9/16" (14 mm) wide or 15/16" (24 mm) wide. Eight
ceiling track clips have been included. Four are for 9/16" ceiling tracks, and four are for
15/16" (24 mm) ceiling tracks. Discard the four that are not required.
4. Attach the ceiling clips to the ceiling grid. Attaching the ceiling clip requires a twisting
motion while applying upward pressure on the clip. Adjoining ceiling tiles may need to
be pushed up to fully attach the ceiling clip. Place the clips in positions to match the
location of the AudioScience microphone's mounting holes at each corner of the top
deflector.
5. Remove the protective paper from all surfaces of the top and rear deflectors.
6. Attach the rear deflector to the top deflector using the two cable suspension assemblies
at the outer mounting holes, and two of both the shoulder screws and Nylon washers.
Tighten the shoulder screws to be "finger-tight." In the same manner, attach the two
remaining cable suspension assemblies to the opposite corner mounting holes of the top
deflector.
7. With the assistance of another person, attach the AudioScience microphone assembly to
the ceiling.
25 25 25 25