11. Conduit Clamp: Retrieve the conduit clamp from the kit bag and fix it to
the pilot hole above the rear access panel on the side which will be closest
to the heat pump storage tank, using a screw provided.
Locate the cable set conduit in the conduit clamp and close the
clamp.
fix conduit clamp to heat pump module and locate cable set conduit
12. Slab or Solid Base: Position the slab or solid base to support the heat
pump module.
Note: The rear edge of the slab or solid base should be placed hard
against or as close as practicable to the wall to enable sufficient area for
the location of the rear dynabolt holes.
Ensure the base or solid base is level.
HEAT PUMP AND TANK ASSEMBLY
Step 11
19