Rheem MPs Series Installation Instructions Manual page 14

HEAT PUMP AND TANK ASSEMBLY
4. Drain Hose: Retrieve the drain hose, hose clamp, saddle and two black
screws from the kit bag.
Feed the hose through the penetration on the side of the heat pump

module
Slip the hose clamp over the upper end of the hose within the heat

pump module
Push the hose over the spigot on the condensate tray located below

the evaporator
Secure the hose to the spigot with the hose clamp

Extend the hose away from the base of the heat pump module using

standard 12 mm irrigation fittings
Secure the hose to the side of the heat pump module with the saddle,

using the two black screws.
feed hose through
penetration
Step 4
secure hose
to the spigot
14
secure hose
with saddle