Advertisement
HEAT PUMP AND TANK ASSEMBLY
6.
Connection Side for Heat Pump Module: Select which side, either the
left or right hand side, of the heat pump module will be used to connect the
heat pump flow and return lines to the flexible braided hoses.
It is recommended to select the side of the heat pump module which is
closest to the heat pump storage tank. This will allow for an easier and
neater installation of the heat pump flow and return pipe work.
The cable set should also be run from this side of the heat pump module
to the heat pump storage tank.
7.
Hose Tabs: Remove the two (2) tabs on the selected side of the heat
pump module to accommodate the flexible braided hoses.
Pliers or tin snips may be required to remove the tabs.
8.
Hose Bracket Assembly: Retrieve the hose mount angle and hose clamp
brackets from the kit bag.
The hose mount angle bracket, when secured to the heat pump module, is
to be angled away from the wall, with the „hot‟ flexible braided hose in the
top slot of the bracket.
Locate the black heat shrink area of the „hot‟ flexible braided hose,
marked with a red collar, into the top slot in the angle hose bracket.
Locate the black heat shrink area of the „cold‟ flexible braided hose,
marked with a blue collar, into the bottom slot in the angle hose
bracket.
Fix the hose clamp bracket to the angle hose bracket, using a screw
provided, to secure the flexible braided hoses in place.
Step 7
remove the two hose tabs
16
Hide quick links:
Advertisement
