Rheem MPs Series Installation Instructions Manual page 18

HEAT PUMP AND TANK ASSEMBLY
10. Rear Access Panel: Retrieve the heat pump module‟s rear access panel.
Loosely position the two flexible braided hoses attached to the hose

bracket assembly in the two tab cut outs.
The „hot‟ flexible braided hose, marked with a red collar, should be in
the top tab cut out.
Position the rear access panel over the opening in the rear of the heat

pump module, with the panel located between the hose clamp
assembly and heat pump module.

Locate the holes in the rear access panel over the holes and
speed fasteners on the heat pump module and fix in position on
the side opposite to the selected location of the flexible braided
hoses, using two of the screws provided.
Position the hose bracket assembly, locating over the two holes in the

rear access panel and the two holes and speed fasteners on the heat
pump module and fix in position, using two of the screws provided.
fix rear access panel and hose bracket assembly
Step 10
to heat pump module
18