Editing Z-Wave Device Names; Edit A Device Module Name; Exclude/Delete Z-Wave Devices; Exclude A Light, Outlet, Or Switch Module - Honeywell Tuxedo Touch Series Installation And Setup Manual

Editing Z-Wave Device Names

Edit a Device Module Name

To edit a device name, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and press the Z-Wave
Setup icon to display the "Z-Wave
Device Management" screen.
b) Highlight the device name and press
the Z-Wave Edit icon.
c) On the "Data Entry" keyboard, press
Clear and enter a new name.
d) Press OK.

Exclude/Delete Z-Wave Devices

Exclude a Light, Outlet, or Switch Module

To exclude a device from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management"
screen.
b) Highlight the device to exclude and
press the Z-Wave Exclude/Delete
icon.
2. At the device module:
a) Press the Function Key to exclude
the device from the keypad.
Automation (cont'd)
ACTION
ACTION
30
NOTES
Enter the new device name by entering it on the
data entry keyboard.
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make
corrections.
The @#$ icon is not available for use at this time.
NOTES
Z-Wave Exclude/Delete -clears the node from the
keypad and resets device to the default setting.
Notes:
• If the device is not excluded, refer to the " Z-
Wave Troubleshooting" section.
• To remove a defective device, refer to the Z-
Wave Troubleshooting section.