Led Test; Calibration Test - Honeywell Tuxedo Touch Series Installation And Setup Manual

LCD Display Test
Perform the LCD Display Test as follows:
ICON
1. Press the Advanced Setup icon.
2. If applicable, enter your Authorized Code.
3. Press the Keypad Test icon.
4. Press the LCD Display Test icon; a series
of screens appear.
After each type of display, you are asked if
the display was proper.
Audio Test
Perform the Audio Test as follows:
ICON
1. Press the Audio Test icon; "Testing.." is
displayed while beeps sound from the
speaker.
At the conclusion of the test, a pop-up "Confirmation
Window" is displayed with the question "Did you
hear Beeping?"

LED Test

Perform the LED Test as follows:
ICON
1. Press the LED Test icon; "Testing.." is
displayed while the 3 LEDs light
sequentially, top to bottom (red, green,
yellow), 5 times.

Calibration Test

If the Touch Screen requires recalibration, do the following:
ICON
1. Select the Calibration icon and using a
stylus, follow the screen directions by
pressing a series of crosshairs (+) and boxes
(❏ ❏ ❏ ❏ ) on the screen until done.
2. If the test was successful, press OK.
3. If the test was unsuccessful, choose to
Retry, Ignore or Exit.
User System Setup (cont'd)
ACTION
ACTION
ACTION
ACTION
25
NOTES
The Emergency screen cannot be
accessed while running the LCD
Display Test.
If the response to all questions is yes, the LCD
Display Test message area of the Diagnostics
screen displays "Passed".
NOTES
When you press Yes, "Passed" is displayed in
the test status column on the "Diagnostics"
screen.
When you press No, "Failed" is displayed in the
test status column on the "Diagnostics" screen.
NOTES
At the conclusion of the test, a pop-up
"Confirmation Window" is displayed with the
question "Did you see chasing LED pattern?"
If you press Yes, "Passed" is displayed in the
test status column on the "Diagnostics" screen.
If you press No, "Failed" is displayed in the test
status column on the "Diagnostics" screen.
NOTES
If the Calibration test was successful, a
confirmation screen appears stating:
"Congratulations Calibration Successful!!!"
If the test was unsuccessful, an error message
appears indicating the Part of the screen that
failed and stating: "Calibration failure, do you
want to retry?"