Automation; Including/Adding Z-Wave Devices; Include/Add A Light, Switch Or Outlet Module - Honeywell Tuxedo Touch Series Installation And Setup Manual

Before a device will work in the home control network, it must be "Included" (added) into the network.
Follow the instructions below to Include a Z-Wave enabled device into a home control network using
the Tuxedo Touch keypad
specific device.
NOTE: Z-Wave applications have not been evaluated by UL.
WARNING: Automation is intended for lifestyle convenience. Do not use automation for life safety and
property protection.
U L
Automation functionality is supplementary only and has not been evaluated by UL.

Including/Adding Z-Wave Devices

Before including Z-Wave devices, each device must be installed according to the manufacturers'
instructions and in their final location and turned on.
Access control functionality has not been evaluated by UL and may not be used in UL Listed
U L
applications.

Include/Add a Light, Switch or Outlet Module

To include a Z-Wave Light, Switch or Outlet module, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) P ress the Z-Wave Include/Add icon.
2. At the device Module:
a) Press the Function Key on the device.
Z-Wave Device Management Icons
Exclude/Delete
Include/Add

Automation

and follow the instructions in the Z-Wave device User Guide for your
ACTION
Remove
Abort
Failed
Note: Z-Wave light modules may vary; follow the
instructions in the User Guide for your specific
device to include properly.
• If a dimmer module was added, an On/Off
button and a slide bar (to control the dimmer)
are displayed.
• If an on/off light, appliance, switch or outlet
module was added, an On/Off button (to
control the device) is displayed.
The keypad displays a series of messages:
Please press function key on device"
"Adding Controller Unit"
"Device added successfully"
Reset
Edit
Default
28
NOTES
"Start add device.
"Adding Slave Unit"
Router
Link
Security