Updating Controllers With New Or Removed Devices; Removing A Secondary Controller; Z-Wave Troubleshooting - Honeywell Tuxedo Touch Series Installation And Setup Manual

Updating Controllers with New or Removed devices

When devices are added or removed from the Z-Wave network, the device information needs to be
updated in the Controllers. To update this information, from the Primary controller, do the following.
ICON
1. Press Add on Primary controller.
2. Press Add on Secondary controller.

Removing a Secondary Controller

To remove the Secondary controller, do the following:
ICON
1. At the Primary Controller keypad:
a) Press Delete.
2. At the Secondary Controller keypad:
b) Press Delete.

Z-Wave Troubleshooting

PROBLEM
Cannot add new device.
Device is within
proper range but
still will not
include.
Highlighted device
will not delete.
Automation (cont'd)
ACTION
ACTION
Make sure Z-Wave device is within range of the keypad. You
may need to move device closer to the keypad. Refer to the Z-
Wave devices' Instruction Guide for proper range.
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the "Home" screen and then
press the Z-Wave Setup icon to display the "Z-Wave Device
Management" screen.
b) If the device does not appear on the screen, press the Z-
Wave Exclude/Delete icon.
2. At the Z-Wave device, press the Function Key. The screen
will display a message "Device Removed".
3. At the Tuxedo Touch Keypad:
a) Include device again.
When deleting a device, if the selected device remains on the
screen, highlight the device name and press the Z-Wave
Removed Failed icon.
36
NOTES
The controller scans for device changes.
The message is displayed:
"Devices added Successfully"
NOTES
Both keypads will display, "Device Removed" and the
Secondary Controller keypad will revert back to the
Primary Controller.
SOLUTION