Cs Options / Operating Modes; Operating Modes - Honeywell Tuxedo Touch Series Installation And Setup Manual

CS Options / Operating Modes

The "CS Options" menu allows you to enable Display Lighting and the EN50131 Display feature.
The "Operating Modes" menu allows you to access "Normal Mode", "Safe Mode" and
"Automation/Demo Mode".
Compliance Feature (EN50131)
The EN50131 Display compliance feature is a European Standard designed to prevent unauthorized
users from knowing the status of the Security System. When the EN50131 Display feature is enabled:
• The keypad returns to the "Home" screen after 30 seconds; "Armed" and "Ready" LEDs turn OFF.
• The "To Homepage After" time setting changes to 30 seconds and the time is non-selectable.
• The "Auto Slideshow After" is preset to "1" minute and can not be changed.
• The Security, Message and Lighting screen does not display system status until an authorized
user code is entered.
• The "Setup" menu does not display system status until an authorized user code is entered.
• Videos can not be played.
From the Home screen, press the Setup and System Setup icon.
ICON
1. Press the CS Options icon.
2. Enter your Authorized Code, if
required.
3. Select "Lighting" or "EN50131 Display"
to turn the option on or off.
4. Select "Normal Mode" or "Safe Mode" to
turn the option on or off.
Apply accepts all changes.

Operating Modes

Safe Mode
The Safe Mode may be automatically entered by the program on a communication failure or may be
entered manually on command.
Automatic Entry
In the rare event that the keypad cannot successfully communicate in its graphic mode with the control
panel, the screen presents you with a message of "Problems detected. Start Keypad in Safe Mode?" and
requests a "Yes" or "No" response. If you answer with "Yes", the keypad goes into the Safe Mode. If you
answer with "No", the keypad tries to communicate with the panel again. After 3 consecutive times of
receiving no response, the keypad enters the Safe Mode automatically.
Manual Entry
Note: ONLY enter the Safe Mode from the Normal Mode. Entering the Safe Mode from the
Automation/Demo Mode may result in incorrect display of the Emergency Function keys.
ICON
1. Select Safe Mode and then press Apply.
! SAFE MODE !
2. Press OK.
3. To exit, touch the safe mode bar and
touch Yes to return to Normal Mode.
System Setup (cont'd)
ACTION
ACTION
18
NOTES
Note: The Automation/Demo Mode option
allows the automation and multi-media
features to operate in a non-security mode.
When this option is selected, the keypad
does not communicate with the control panel
and any user can select Advanced Setup
screens.
NOTES
The "Warning" message "Keypad will reset to
activate changes" is displayed.
The keypad resets and restarts in the Safe
Mode.