Editing Z-Wave Device Names; Remove/Delete Z-Wave Devices; Remove/Delete A Door Lock - Honeywell Tuxedo Touch Series Home Automation System User Manual

Editing Z-Wave Device Names

Edit a Device Module Name
To edit a device name, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the "Home" screen
and press the Z-Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Highlight the device name and press the Z-Wave Edit
icon.
c) On the "Data Entry" keyboard, press Clear and enter
a new name.
d) Press OK.

Remove/Delete Z-Wave Devices

Remove a Light, Switch or Outlet Module
To remove a light, switch or outlet module from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the "Home" screen
and then press Z-Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Highlight the device to remove and press the Z-Wave
Remove/Delete icon.
2. At the device module:
a) Press the Function Key to remove the device from
the keypad.

Remove/Delete a Door Lock

To remove a door lock module from the Z-Wave network, do the following:
ICON
1. From the "Home" screen, press the Automation icon
and the Z-Wave Setup icon. The "Z-Wave Device
Management" screen is displayed.
2. Highlight the device to remove and press the Z-Wave
Remove/Delete icon.
3. On the door lock press the Function Key to remove the
device from the keypad.
Automation (cont'd)
ACTION
ACTION
ACTION
35
NOTES
Enter the new device name on the data entry keyboard.
Notes:
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make corrections.
The @#$ icon is not available for use at this time.
NOTES
Z-Wave Remove/Delete -clears the node from the keypad and
resets device to the default setting.
Note:
• If the device is not removed, or to remove a defective
device, refer to the "Z-Wave Troubleshooting" section.
NOTES
Z-Wave Remove/Delete -clears the node from the keypad and
resets device to the default setting.
Notes:
• If the device is not removed, or to remove a defective device,
refer to "Z-Wave Troubleshooting".
• When excluding the door lock, the user code associated with the
door lock will remain in the system. If needed refer to the panel
Installation Instructions on how to remove this user code.