Samsung SRN-4000 User Manual page 65

Adding an iSCSi device manually
1. On the iSCSI screen, click <Add manually>.
2. On the Manual Add screen, enter the IP address, the connecting port, the ID and the password, and click
<oK>.
Canceling registration of iSCSi devices
1. In the <iSCSi usable name> list, select an iSCSI device to delete.
2. Click on the <delete> button to launch the Delete window.
3. If you click <oK>, the iSCSI device is removed from the list.
iSCSI devices use an iSCSI port only.
`
M
When using a hub to connect an iSCSI device with NVR, make sure to use the GIGA hub and to use an independent network
`
to save data normally.
In an iSCSI device, a logical drive must not exceed 16TB.
`
When you perform single directional CHAP authentication in vers. RAID, an iSCSI device in compliance with the NVR, you
`
need to use the iSCSI Manual Add function to make a connection to iSCSI.
If multiple NVRs try to access a single iSCSI device, it can cause a problem.
`
When the NVR is connected to an iSCSI device, if you change the iSCSI equipment setting, a problem can occur.
`
A HDD to be mounted in vess RAID should be listed in the RAID compatibility list.
`
If you activate the LUN mapping function for an iSCSI device, it will not be registered in the NVR.
`
iSCSI equipment only supports a volume of RAID 5/6. (Each array should be composed of 5 to 6 HDDs for use.)
`
When you register an iSCSI device in the NVR for the first time, you need to format it first.
`
English _65