Add Paper Symbol; Adding Paper To The Cassettes - Toshiba e-studio 45 Operator's Manual

2. ADD PAPER SYMBOL

Adding Paper to the Cassettes

When the paper supply in the selected cassette or the large-capacity feeder (optional) runs out, the
cassette or large-capacity feeder shown on the display flashes, and the following message appears:
Add paper
Add paper as follows.
1 Pulling up the cassette grip, draw out the cassette
carefully until it comes to a stop.
2 Open a paper package, take out whole ream of pa-
per and place it in the cassette.
• Up to 550 sheets of paper (60 mm high) (recommended by
Toshiba) can be set.
• Do not add paper above the line indicated on the guide.
• Do not use creased, folded, wrinkled or damp sheets of
paper.
Note
Make sure that a gap of approx. 0.5 mm (less than 1 mm in
total) is left between the paper and the side guide. If there is
no gap, this would cause paper misfeeding.
3
Push the cassette straight in until it comes to a stop.
• Be sure to push the cassette fully in, taking care.
• The same procedure can be used to add paper to any of
the cassettes in the paper feed pedestal (optional).
Approx. 0.5 mm
Side guide
Side guide
Approx. 0.5 mm
1
2
3
4
5
6
7
8
9
10
11
12
7-3