Saddle Stitching Unit (Optional) - Toshiba e-studio 45 Operator's Manual

Saddle Stitching Unit
1
Open the lower cover of the finisher.
2
Slide out the saddle stitching unit carefully toward
the front.
3
Pull out the grip of the saddle stitch holder toward
you and turn it 90 degrees clockwise.
4
Remove the empty staple case and set a new one.
• Replace both staple cases with new ones.
5 Return the saddle stitch holder and the saddle
stitching unit to their respective original positions.
6
Make sure that the finisher is attached to the copier
firmly and that either of LD, LG or LT-R size of pa-
per is set in the copier.
• If any of the above paper sizes is not set, test stapling can-
not be performed. Set either of LD, LG or LT-R size of paper.
7 Close the lower finisher cover. Then, test stapling
is automatically carried out on a blank sheet.
• This operation is carried out to avoid empty stitching.
1
2
3
4
5
6
7
8
9
10
11
12
7-23