Chapter 7—Setup Mode
Entering Setup Mode at Installation
The method of entering the Setup Mode depends on which startup fi les
are stored in the printer's memory, a subject that was more thoroughly
discussed in Chapter 3, "Starting Up."
EasyCoder PF2i with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...", press the
<Enter> key.
• Press the <Setup> key (this facility can be used anywhere within
Intermec Shell and also outside Intermec Shell provided there is no
application program running that disables the <Setup> key).
• Set up the printer as described in this chapter.
• Exit the Setup Mode by pressing the <Setup> key.
EasyCoder PF2i with a custom-made application program
• Normally, there is no need to enter the Setup Mode when using appli-
cation programs that start up automatically. Necessary provisions for
changing the setup, manually or automatically, should be provided by
the program.
60
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)