Setting Up The Camera Using The Mac Address On The Setup Program - Panasonic BB-HCM331A Installation/Troubleshooting Manual
Network camera
Hide thumbs
Also See for BB-HCM331A:
- Operating instructions manual (151 pages) ,
- Operating instructions manual (53 pages) ,
- Operating instructions manual (150 pages)
Table of Contents
Advertisement
Installation/Troubleshooting
1.10 Setting up the Camera Using the MAC
Address on the Setup Program
The Setup Program may not list any cameras due to your firewall or antivirus
software settings on your PC. If you cannot disable your firewall or antivirus
software, you can set up the camera using the camera MAC address as shown
below.
1.
Enter the camera MAC address in the data field, and click [Set up camera].
Note
The cameras MAC address can be found on the sticker affixed to the rear of
the camera (see page 13).
2.
After confirming the network settings, click [OK].
•
After about a minute, the Security: Administrator page is displayed.
28
Advertisement
Table of Contents
