Setting Up The Camera Using The Mac Address On The Setup Program - Panasonic BL-C1A Operating Instructions Manual

Operating Instructions
Setting up the Camera Using the MAC Address on the Setup
Program
The Setup Program may not list any cameras due to your firewall or antivirus
software settings on your PC. If you cannot disable your firewall or antivirus
software, you can set up the camera using the camera MAC address as shown
below.
1.
Enter the camera MAC address in the data field, and click [Set up camera].
Note
The camera's MAC address can be found on the sticker affixed to the rear
of the camera (see page 5 or page 6).
2.
After confirming the network settings, click [OK].
• After about a minute, the Security: Administrator page is displayed.
124