Table of Contents
Advertisement
Tools required
To install or remove some options in your computer, you will need a
flat-blade screwdriver. Additional tools might be needed for certain
options. See the instructions that come with the option.
Important
Run ConfigSafe (or a similar application) to take a snapshot of your
computer configuration before installing an optional device. Using this
snapshot, you can view and compare the changes in the computer
configuration after you install an option. Also, if you have problems
configuring the option after it is installed, ConfigSafe allows you to
restore the configuration to the previous settings.
Note: If you have preinstalled software, ConfigSafe took a snapshot of
the initial configuration of your computer when you started your
computer for the first time. You might be able to use this
snapshot to restore the configuration to the initial settings.
ConfigSafe is a part of the preinstalled software in your computer. For
more information, see "Using the ConfigSafe program" on page 126
and "Software" on page 5.
Using the stabilizing feet
The four feet attached to the bottom cover rotate 90° to provide additional
stability for your computer.
When you need to access the inside of the computer, you might find it
easier to place the computer on its side. If you do so, rotate the feet inward
so they do not break off due to the weight of the computer.
When you are finished installing options and have reinstalled the side
cover, rotate the four stabilizing feet a quarter turn and place the computer
carefully back on its feet.
Chapter 5. Installing options
63
Advertisement
Table of Contents
Troubleshooting
