Required Ssrs And Roles; Estimated Service Time; Required Tools; Prerequisites For This Procedure - IBM Power775 Service Procedure

2.7

Required SSRs and Roles

This service procedure requires two SSRs.
This service procedure contains steps to be performed by a customer system administrator and an IBM SSR
(System Service Representative).
The customer system administrator performs the STEPs in Sections marked with "<= CUSTOMER
•
TASK"
The SSR performs the STEPs in Sections marked with "<= SSR TASK"
•
2.8

Estimated Service Time

The time required to unpack a new chassis, change out a DE chassis and package the damaged chassis to be
shipped back to IBM is about 4 hours.

2.9 Required Tools

Service card (shipped in the Power 775 frame)
Fill and Drain Tool P/N 45D6928.
Cable Assembly, HPIC tool P/N 45D7998 (shipped in Power 775 Fill & Drain Tool Kit)
•
Cable Assembly E/Net (test tool) P/N 45D8000 (shipped in Power 775 Fill & Drain Tool Kit)
•
Lift Tool Kit 74Y1087
Ladder PN 46G5947 may be required for upper DE locations (shipped in the Power 775 Lift Tool
•
Kit)
Hand Tool Kit P/N 74Y0988
Torque Clutch P/N 74Y0985 (shipped in the Hand Tool Kit)
•
Ratchet handle P/N 6428240 (shipped in the Hand Tool Kit)
•
Extension (18") P/N 46K2707 (shipped in the Hand Tool Kit)
•
2 mm Hex Torque Driver P/N 74Y0983 (shipped in the Hand Tool Kit)
•
3 mm Hex Torque Driver P/N 74Y0998 (shipped in the Hand Tool Kit)
•
4mm Hex Torque Driver PN 41V1059 (shipped in the Hand Tool Kit)
•
5 mm Hex tool P/N 74Y0986 (shipped in the Hand Tool Kit)
•
10 mm Socket P/N 02F3582 (shipped in the Hand Tool Kit)
•
2.10

Prerequisites for this Procedure

In order to perform this procedure, you will need the following information:
1) The location code of the DE to be serviced.
2) The frame number and frame serial number of the DE to be serviced.
Power775 Disk Enclosure Chassis Service Procedure
Page 14 of 171