IBM IntelliStation M Pro Type 6868 User Manual page 105

2. Remove the lower drive bracket for bays 5, 6, and 7. If there are drives
already installed in the lower drive bracket, you might have to
disconnect the cables attached to them in order to install the new drive.
Make sure to note where the cables are attached.
3. The screws for mounting a drive in the lower drive bracket are in the
conversion bracket installed in drive bay 2. See "Installing Drives in
Bays 1, 2, or 3" on page 86 to access the upper drive bracket. If the
screws provided in the bracket have already been used, order kit P/N
10L5600 from your IBM reseller or IBM marketing representative. This
kit includes a variety of screws.
Install the drive into the lower drive bracket so that the power and
signal cable connectors are to the rear of the computer. Align the
screw holes and insert the four screws.
Chapter 5. Installing options
89