Table of Contents
Advertisement
4. Operation
4-4 Suspending a beep
You can suspend a beep by pressing and holding the Beep Stop/Test Switch while a beep is sounding for 0.5
second or longer.
You can suspend a beep in the following statuses.
● During Battery Mode
When the Battery Mode is resumed and the battery goes weak, a beep sounds again.
In this case also, you can suspend a beep.
● When a failure occurs in equipment (the Alarm Lamp is on)
● When battery replacement is required (the Alarm Lamp blinks at intervals of 2 seconds)
You cannot suspend a beep when connection capacity is exceeded.
Take necessary countermeasures according to the remedy of No.7 in "4. Display and beep when a failure
occurs in equipment" on page 21.
4-5 Description of the self-diagnostic test function
You can use the following procedure to check whether a failure occurs inside the UPS and whether replacing
the battery is required.
If the battery is not fully charged, the self-diagnostic test is not executed immediately.
After charging is complete, it is automatically executed.
(1) Connect your computer and other devices to the UPS and then turn on the power switch of the UPS.
(2) Press and hold the Beep Stop/Test Switch of the UPS for 0.5 second or longer.
Release the Beep Stop/Test Switch when a beep sounds. The Battery Mode starts for testing purpose. (No
beep sounds.) When the test is complete, the normal operation automatically starts.
(3) If the Alarm Lamp blinks and the beeper sounds:
"4-3 Interpreting a beep and display" ➛ Page 21
See also
Take necessary countermeasures according to the remedy in "4. Display and beep when a failure occurs
in equipment." or "5.Display and beep when battery replace."
22
Advertisement
Table of Contents
