Table of Contents
Advertisement
immobilizer jumper setting
jumper in setting
When the jumper is in, the ignition and starter signal will bypass the UltraSecure
immobilizer circuitry and allow the vehicle start and run, even if power has not been
restored to the module.
jumper out setting
When the jumper is out, the UltraSecure immobilizer circuitry prevents the ignition
and starter signal from passing and keeps the vehicle immobilized until power has
been restored to the module.
N N O O T T E E : : In order for the system to bypass the immobilizer with the jumper in place, the
unit must have ground on the 18-pin harness.
door lock harness wire connection guide
door lock harness wiring guide
h2/1-h2/6 power door locks
The system has door lock relays on-board, and can directly interface with most elec-
tric power door lock systems drawing 20 amps or less.
identifying the door lock system
For help in identifying the door lock system, please refer to Directed document 1041.
The easiest way to determine which type of door lock system you are working with is
to remove the master locking switch itself, which is usually on the driver's door or on
the center console. Once you have determined which type of factory door lock circuit
you are working with, and the color codes of the switch wires to be used, you can usu-
ally simplify the installation by locating the same wires in the vehicle's kick panel.
N N O O T T E E : : Always retest the kick panel wires to make sure they work the same as the
wires on the switch.
10
www.directed.com
Hide quick links:
Advertisement
Table of Contents
