Table of Contents
Advertisement
immobilizer harness wire connection guide
immobilizer harness wiring
Locate the ignition and starter wires using a multimeter. Cut the appropriate wire and
attach the key side and car side wires to the corresponding wires on the four-pin
immobilizer harness.
N N O O T T E E : : The diagram below shows the module side of the connector (looking into the
female pins).
H3/1 Starter Side
H3/2 Starter Key Side
Ignition
ultrasecure immobilizer
The UltraSecure immobilizer circuit in this G5 system is a unique new design that
incorporates the immobilizer security of Clifford without the possibility of failure due
to power loss that could potentially strand the user. The level of security can be set by
leaving in or removing the jumper located next to the immobilizer wires exiting the
module.
immobilizer jumper setting
jumper in setting
When the jumper is in, the ignition and starter signal will bypass the UltraSecure
immobilizer circuitry and allow the vehicle start and run, even if power has not been
restored to the module.
jumper out setting
When the jumper is out, the UltraSecure immobilizer circuitry prevents the ignition
and starter signal from passing and keeps the vehicle immobilized until power has
8
Starter
x
CUT
x
CUT
H3/4 Ignition Car Side
H3/3 Ignition Key Side
www.directed.com
Hide quick links:
Advertisement
Table of Contents
