Installer Selectable Features - Clifford IntelliGuard 850 Installation Manual

installer selectable features

To enter the Installer Selectable Features grid follow the instructions for the User
Selectable Features with the exception of step 4. Perform step 4 as described below
to enter the Installer Selectable Features grid.
Hold/Chirp/Release - After entering the PIN code, press and hold
chirps once. Continue holding for approximately 10 seconds until the siren chirps
three times, then release the button. You have now entered the feature selection posi-
tion of the Installer Selectable Features grid.
First
Press
Then
Press
off/arm/disarm/both
latch (ignition reset)
* P1 = Pulsed channel output is disabled with the ignition on or the alarm is
armed.
** P2 = Pulsed channel output works anytime.
*** Only with optional IntelliStart connected.
**** Only with optional SmartWindows connected.
© 2004 directed electronics, inc.
Lock pulse Acc. output A P1*/
single/double P2**/timer A/latch/
latch (ignition reset)
Unlock pulse Acc. output B P1*/
single/double P2**/timer B/latch/
latch (ignition reset)
Lock pulse One time valet
duration
0.8/3.5 sec
Delay domelight Timer A duration
off/on for acc output A
Acc. output C
Timer B duration
auto-activate
for acc output B
Acc. output C P1*/
Timer C duration
P2**/timer C/latch/
for acc output C
Program RPM
Engine type
petrol/diesel***
Program
off/on SmartWindows 4****
Horn output
pulsed/latched
Auto immobilization
off/on
Not used
until the siren
31