Table of Contents
Advertisement
horn output - pulsed/latched
Pulsed: H2/9 YELLOW/WHITE wire will generate a pulsing (-) output when the
alarm is in full trigger. When arming and disarming the output does not operate.
Latched: H2/9 YELLOW/WHITE wire will generate a constant (-) output when the
alarm is in full trigger. When arming and disarming the output will pulse as per
the standard chirp pulses.
auto immobilization - off/on
Off: Turns the auto immobilization feature off.
On: Turns the auto immobilization feature on.
programming notes
Note #1: Adding a new transmitter in auto-learn configuration
Press the arm/disarm button of the Radar 2 remote control; the siren will chirp
once.
Immediately press arm/disarm again; the siren will chirp twice to confirm the
new transmitter has been programmed.
Note #2: Adding a new transmitter in custom-configuration
For the arm/disarm channel, transmit the channel of the new three, four, or five but-
ton transmitter that you want to control that feature; the siren will then chirp once.
Immediately transmit the same channel again, the siren will chirp twice to con-
firm the transmitter channel has been programmed.
For the rest of the channels only one press of the button is required to learn, and
the siren will chirp the same number of times as the feature row.
N N O O T T E E : : When programming a new transmitter to custom configuration, an arm/dis-
arm channel must first be programmed before programming the remaining channels.
Note #3: Selecting siren sounds
After entering this feature, press the arm/disarm button. The siren will generate a five-
second sample of each available siren sound. Perform the following steps to add or
delete that specific sound.
Add sound: Press
sound to add that sound.
Delete sound: Press
desired sound to delete that sound.
© 2004 directed electronics, inc.
on the PlainView 2 Valet switch while playing the desired
on the PlainView 2 Valet switch while playing the
35
Hide quick links:
Advertisement
Table of Contents
