Ultrasecure Immobilizer; Immobilizer Jumper Setting - Clifford AvantGuard 5 Installation Manual

ultrasecure immobilizer

The UltraSecure immobilizer circuit in this G5 system is a unique new design that
incorporates the immobilizer security of Clifford without the possibility of failure due
to power loss that could potentially strand the user.
The level of security can be set by leaving in or removing the jumper located next to
the immobilizer wires exiting the module.

immobilizer jumper setting

jumper in setting
When the jumper is in, the ignition and starter signal will bypass the UltraSecure
immobilizer circuitry and allow the vehicle start and run, even if power has not been
restored to the module.
jumper out setting
When the jumper is out, the UltraSecure immobilizer circuitry prevents the ignition
and starter signal from passing and keeps the vehicle immobilized until power has
been restored to the module.
N N O O T T E E : : In order for the system to bypass the immobilizer with the jumper in place, the
unit must have ground on the 18-pin harness.
© 2004 directed electronics, inc.
15