Table of Contents
Advertisement
Use one of the following methods to turn off auto-immobilization:
Turn ignition on and press the arm/disarm button of the transmitter.
Arm the alarm and then disarm the alarm.
Turn the ignition on and enter the system valet/PIN code.
one-time valet feature
This feature allows the system to be put in valet mode only until the next time the
ignition is turned off.
ON: Valet mode will be exited every time the ignition is turned on.
OFF: Valet mode will only be exited by using the valet switch or the remote control.
blackjax feature
blackjax activation sequence
When BlackJax is programmed ON, BlackJax sequence will begin every time the igni-
tion is turned on and must be turned off by entering your PIN code. It will then acti-
vate again while driving when triggered as described below.
N N O O T T E E : : BlackJax can be turned off by entering PIN code at any time.
1.
Ignition on (engine does not have to be running).
System sees input on Zone 7 ignition input.
2.
Door Open & Close.
System sees input on H1/8 or H1/9 Door trigger input.
3.
Press and release brake pedal.
a.
System sees (+) input on H2/11 BROWN/WHITE brake input/output wire.
b.
System then begins monitoring input on H1/4 VIOLET/BLACK wire or
Intellistart 4.
c.
System sees RPM at or above 2 x programmed rate, BlackJax begins 20
second countdown.
4.
After a 20 second countdown:
a.
5 siren chirps as reminder to enter PIN code.
b.
Brake light relay pulses (+) 12v on H2/11 BROWN/WHITE to flash brake lights.
c.
You then have 20 more seconds to enter PIN to turn off Blackjax.
© 2004 directed electronics, inc.
39
Hide quick links:
Advertisement
Table of Contents
