Mitel 1000 Owner's Manual page 80

Press the Speakerphone Key to finish programming.
To configure unequipped line interfaces
The system assumes that available line interfaces have CO lines
connected to them. If a line interface does not have an CO line
connected ensure correct system operation by unequipping the line
interface in system programming, as follows:
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Lines'.
Press the Scroll Down Key ( ) until 'Equipped Lines' is displayed.
Select 'Equipped lines'.
Select the lines you wish to equip or unequip. Equipped lines are
denoted by a ♦. Unequipped lines are denoted by a ◊.
Press the Speakerphone Key to finish programming.
To configure disconnected extensions
The system assumes that all available extension interfaces have
Desk Phones connected to them. If an extension interface does not
have a Desk Phone connected, ensure correct system operation by
disconnecting the extension interface in system programming, as
follows
From the Programming extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Extensions'.
Press the Scroll Down Key ( ) until 'Extension disconnect' is
displayed.
Select 'Extension disconnect'.
Select the extensions you wish to connect or disconnect.
Disconnected extensions are denoted by a ♦.
Press the Speakerphone Key to finish programming.
When a Desk Phone is connected to an extension interface that is
programmed as disconnected, the Desk Phone display may
appear as if the Desk Phone is connected. However, when the
handset is lifted a busy tone is heard and no options will be
Note
displayed.
To examine system passwords
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key ( ) until 'System programming' is
displayed.
Select 'System programming'.
Enter the System Programming Password and select 'Extensions'.
Press the Scroll Down Key ( ) until 'Examine passwords' is
displayed.
Select 'Examine passwords'.
80