Replacing A Hard Disk Drive - Fujitsu Siemens Computers SCENIC S 2 Operating Manual

Replacing a hard disk drive

Ê
Open the casing (see "Opening the casing").
Ê
Disconnect the cables between the hard disk drive and the mainboard at the hard disk drive.
1
2
Ê
Lightly press on the clips in the direction of the arrow (1).
Ê
Pull the hard disk drive out of the drive cage (2).
Ê
Take the new hard disk drive out of its packaging.
Ê
Make the required settings (e.g. master-slave settings) on the drive.
A26361-K650-Z100-1-7619
1
Ê
System expansions
Remove the EasyChange rails from the
hard disk drive by pulling them off carefully.
55