System expansions
Installing/removing hard disk drive and drive cage with
screws
This chapter only applies to the SCENIC Edition X102.
i
On the SCENIC Edition X102, both hard disks can only be secured with screws. In
addition, the drive cage must also be removed first.
Removing a hard disk drive
►
Open the casing (see "Opening the casing").
►
Disconnect all connected cables (data cable, power supply) from the drives already installed.
►
Unscrew the two screws on the drive cage (1).
►
Pull the drive cage upward (2) out of the casing.
►
Unscrew the four screws (3) which secure the hard disk drive on the drive cage.
►
Pull the hard disk drive out of the drive cage (4).
►
Push the drive cage into the bracket (5) of the casing again.
►
Mount the drive cage with the two screws (6).
46
1
2
4
3
3
6
5
A26361-K678-Z121-1-7619, edition 1