Before Requesting Help - Panasonic KX-TCD952BLB Operating Instructions Manual

KX-TCD952BL(E)43~51

Before Requesting Help

Problem
The unit does not work.
" " flashes and an alarm tone sounds
when you press
A busy tone sounds when you
press .
You cannot dial.
" " flashes during a conversation and
the call is disconnected.
Static, sound cuts in/out, fades.
Interference from other electrical units.
The handset does not ring.
The base unit does not ring.
18/4/00 15:07 Page 45
· Turn the power ON (p. 11).
· Check the settings (p. 8–13).
· Charge the batteries fully (p. 10).
· Clean the charge contacts and charge again (p. 10).
· Unplug the AC adaptor and turn the power OFF to
· The handset has been canceled or has not been
· Re-install the handset batteries and try again.
· You are too far from the base unit. Move closer and
.
· Plug in the AC adaptor.
· Another handset is in use.
· The unit is in call prohibition mode. Cancel the mode
· The dialed number is restricted. Cancel the number
· Key lock mode is set. Cancel the mode (p. 22).
· The handset is out of range. Move closer to the base
· Plug in the AC adaptor.
· Locate the handset and base unit away from other
· Move closer to the base unit.
· Turn the power ON (p. 11).
· The ringer is set to OFF. Select the desired volume
· The ringer is set to OFF. Set to HIGH, MEDIUM or
Remedy
reset. Plug in the AC adaptor and turn the power ON.
Then try again.
registered. Register the handset (p. 35).
try again.
(p. 27).
(p. 28).
unit and make the call again.
electrical appliances (p. 3).
level (p. 12).
LOW (p. 13).
45