Registration; Registering A Handset In The Base Unit - Panasonic KX-TCD952BLB Operating Instructions Manual

KX-TCD952BL(E)34~42

Registration

Registering a Handset in the Base Unit

You must register the handset in the base unit before use.
· Charge the optional handset batteries for about 4 hours before initial use.
· Make sure that the power is ON (p. 11) and the unit is in the stand-by mode.
· Register the handset number within 1 minute. If not registered within 1 minute, press
the handset to cancel the programming mode. Then start again from step 1.
1
Base unit where handset is to be
registered:
Press and hold
for more than 10 seconds until the in
use indicator (
confirmation tone sounds.
2
Handset:
Press .
3
Press or
4
Press .
OK
· The available base unit numbers are
displayed.
F7 iU i234
5
Press the desired base unit number
to 4 .
· The number is assigned as the base unit
number for the handset.
· While the handset is searching for the
-
base unit, " " flashes across on the
display.
-
18/4/00 15:06 Page 35
on the base unit
) lights and a
until " F7 i " is displayed.
1
6
Enter the base unit password (p. 25).
F7 io
- - - -
7
Press .
· A confirmation tone sounds and the
display will return to the stand-by mode.
· The in use indicator (
unit will go out.
· To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
· The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 38). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
on
) on the base
35