Before Requesting Help.67 - Panasonic KX-TGA420B Operating Instructions Manual

Before Requesting Help
Telephone
Problem
j
Remedy
The unit does not work. 1
1
• Be sure that the AC adaptor is connected
properly {p. 9),
• Charge the battery fully (p. 10).
• Install the battery properly (p. 8, 59).
• The unit has not been registered to the base
unit. Register it to the base unit (p. 12, 13).
• The base unit backup battery has been
discharged during a power failure.
"No link to base.
Walk closer to
base
Sc
try
again" is
displayed and an alarm
tone sounds.
• You are too far from the base unit. Locate
the station unit near the base unit and try
again.
• Raise the antenna.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
• Locate the station unit and the base unit
away from other electrical appliances.
• Locate the station unit near the base unit.
• Raise the antenna.
The unit does not ring.
•The ringer volume is set to OFF. Select
HIGH or LOW (p. 16).
• If registered to KX-TG4000B:
If 4 other units are in use, the station unit
may not ring. Those users will hear
incoming call tones.
• If registered to KX-TG2000B:
If more than one unit is in use, the station
unit may not ring. Those users will hear
incoming call tones.
•The unit is removed from the ring group of
the line by the base unit.
1 You cannot dial.
t
•The dialed number is restricted by the base
unit.
The display is blank.
•The battery has been discharged. Connect
the AC adaptor to charge the battery fully
(p. 9).
For assistance, please call: 1-800-211-PANA(7262)
67