Selecting The Stand-By Mode Display; Bell Selection - Panasonic KX-TCD952BLB Operating Instructions Manual

KX-TCD952BL(E)34~42

Selecting the Stand-by Mode Display

You can choose to display whether the currently connected base unit number, handset number or no
display while in the stand-by mode. The factory preset is the base unit number.
1
Press
2
Press or
then press
OK
· The current setting is displayed.
1: Base unit number
2: Handset number
F3 i0 i

Bell Selection

There are three choices for bell selection. When a call is being received:
— all handsets ring. "All handsets"
— the selected handset(s) ring(s). "Specified handset(s)"
— the selected handset rings first, then if it does not answer, all other handsets will ring. "First handset"
The factory preset is "All handsets". To change the bell selection, program as follows.
Selecting specified handset(s)
You can choose which handset(s) you want to ring.
1
Press
2
1
Press .
3
Enter the base unit password (p. 25).
· The current setting is displayed.
1: All handsets
2: Specified handset(s)
3: First handset
Ex. All handsets is selected.
iu i
38
18/4/00 15:06 Page 38
.
until " F3 i " is displayed,
.
0: No display
IN T
then .
3
Press or to select the desired
setting.
· You can also press
1
select the setting.
4
Press .
· A confirmation tone sounds and the
display will return to the stand-by mode.
Ex. Handset number is selected.
[ 2 ]
4
2
Press .
· The current registered handset number(s)
is/are displayed.
Ex. Handset 1, 2, 3, 4, 5 and 6 are registered.
iu2 - i23456
5
Enter the handset number(s) you want to
ring.
· The selected handset number(s) flash(es).
· If you misdial, press the number(s) again.
6
Press .
· A confirmation tone sounds and the
display will return to the stand-by mode.
2
0
, or to
00