Table of Contents
Advertisement
30678_KX-TCD705G_a_English
Before Requesting Help
Problem
"Î" flashes and an alarm tone
sounds when you Z O or %.
A busy tone sounds when you
Z O or %.
"Î" flashes during a conversation
and the call is disconnected.
The unit does not work.
You cannot dial.
Static, sound cuts in/out, fades.
Interference from other electrical
units.
The handset does not operate
or ring.
The base unit does not ring.
8/5/01
6:58 am
Page 53
• You are too far from the base unit. Move closer and
•
try again.
• Plug in the AC adaptor.
• The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 41).
• If the handset is registered to more than one base
unit, check 'selecting the base unit access' (p. 42).
• Another handset is in use.
• The handset is out of range. Move closer to the
•
base unit and make the call again.
• Plug in the AC adaptor.
• Turn the power ON (p.12).
• Check the settings.
• Charge the batteries fully (p.7).
• Clean the charge contacts and charge again (p.7).
• Unplug the AC adaptor and turn the power OFF to
reset. Plug in the AC adaptor and turn the power
ON. Then try again.
• Re-install the handset batteries (p.7) and try again.
• The handset has been cancelled or has not been
registered. Register the handset (p. 39, 41).
• The unit is in call prohibition mode. Cancel the mode
(p.38).
• The dialled number is restricted. Cancel the number
(p.45).
• Key lock mode is set. Cancel the mode (p.36).
• Locate the handset and base unit away from other
•
electrical appliances.
• Move closer to the base unit.
• Turn the power ON (p.12).
• The ringer is set to OFF. Select the desired volume
level (p.37).
• The ringer is set to OFF. Select the desired volume
level (p.44).
49
Cause and Remedy
Advertisement
Table of Contents
