Switch Box Installation; Installation Warnings - Travis Industries Northfield GS2 Owner's Manual

Lopi direct vent freestanding stove, natural gas or propane, vent horizontally or vertically, standard residential, mobile home approved
Table of Contents

Advertisement

Installation

Installation Warnings

!
Failure to follow all of the requirements may result in property damage, bodily injury, or even
death.
!
This heater must be installed by a qualified installer who has gone through a training program for
the installation of direct vent gas appliances.
!
This appliance must be installed in accordance with all local codes, if any; if not, in U.S.A. follow
ANSI Z223.1 and NFPA 54(88), in Canada follow B-149.
!
In Manufactured or Mobile Homes must conform with: In USA, Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4 and Gas-Equipped
Recreational Vehicles and Mobile Housing. This appliance may be installed in Manufactured
Housing only after the home is site located.
!
This stove is designed to operate on natural gas or propane (LP).
!
All exhaust gases must be vented outside the structure of the living area. Combustion air is
drawn from outside the living area structure.
!
Notify your insurance company before hooking up this stove.
!
The requirements listed below are divided into sections. All requirements must be met
simultaneously. The order of installation is not rigid – the qualified installer should follow the
procedure best suited for the installation.

Switch Box Installation

NOTE: This step is not required when installing the GreenSmart 2 Remote. The switch box and
wiring may be discarded (or used for spare parts) when using the GreenSmart 2 remote.
The switch box is shipped detached on this stove. Attach it following the directions below.
a) Loosen the three screws used to secure the switch box.
b) Loosen the three screws holding the wire cover. Remove the wire cover and place it aside.
c) Slide the switch box into place and secure with the three screws.
d) Slide the wire cover into place, making sure it does not pinch any wires. Secure with the
three screws.
© Travis Industries
(for qualified installers only)
4121120
7
100-01315

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lopi northfield gs2

Table of Contents