Maintaining Your Stove's Appearance; Painted Surfaces; Enamel Surfaces; Patina Surfaces - Travis Industries Northfield GS2 Owner's Manual

Lopi direct vent freestanding stove, natural gas or propane, vent horizontally or vertically, standard residential, mobile home approved
Table of Contents

Advertisement

Maintenance

Maintaining Your Stove's Appearance

Painted Surfaces

Painted surfaces should be cleaned with a duster. If scratches occur, lightly sand the area with fine sandpaper.
Clean the area and, with the stove cool, apply one or two thin coats of stove paint to the area (mask the area to
avoid overspray). Allow the stove to dry, then turn the stove on to cure the paint (1 hour on medium).

Enamel Surfaces

Use only soft cloth and water to clean enamel surfaces. To fix chips in the enamel, follow the directions below:
1)
Let the stove cool. Clean the area thoroughly.
2)
Shake the Travis Enamel Touch-Up thoroughly. Apply to the damaged area.

Patina Surfaces

The patina finish is a "living" color and will age and antique over time. Some portions of the finish may become
slightly dull in appearance, especially over the top where it becomes hot. This is normal. The only cleaning we
recommend is a light dusting when the appliance is cool.
DO NOT USE ANY LIQUID, CLEANER, OR ABRASIVES ON THIS FINISH.

Glass

Clean the glass with soap and water (do not use abrasive cleaners). Glass removal instructions are on page 29.

Battery Replacement

Power Backup Batteries

Four AA batteries are used as a power backup for the stove in case the household (AC) power goes out. They also
power the comfort control feature. These batteries must be inserted into battery holder (make sure they contact the
terminals - see the illustration below). The stove controller will beep once these batteries start to go dead. Replace
batteries before each heating season to insure proper operation.

Control Panel Light Battery

LED lights and a 9v battery are used to illuminate the control panel when the concealment cover is opened. If the
LED lights do not operate, replace the 9v battery (see the illustration below). Velcro is used to secure the 9v battery.
© Travis Industries
(for qualified service personnel only)
4121120
39
100-01315

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lopi northfield gs2

Table of Contents