Log Installation; Rear Log Placement - Travis Industries Northfield GS2 Owner's Manual

Finalizing the Installation

Log Installation

! The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.

Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.

If using propane (LP), convert the appliance before installing the logs (see page 44).

The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned. See page 44 for details on burner removal.

Rear Log Placement

The rear log has two holes on the bottom. Place the log so the pins on the burner insert into the
holes on the log (see photos below).
© Travis Industries
(for qualified installers only)
4121120
31
100-01315