Menu Features And Programming Instructions; Programming The Primary Filtration Menu - Jacuzzi J-135 Owner's Manual

11.0

Menu Features and Programming Instructions

Your hot tub is equipped with menus that allow you to program additional
features. By continually pressing the Menu (
through the menus as follows (Figure 11.0a):
Current temperature (Main Menu)
Primary Filtration (page 29)
Heat (page 30)
Filter Change (page 31)
UV (not applicable)
H2O (page 31)
Time (page 32)
Date (page 32)
Temp (page 33)
Language (page 33)
Lock (page 33)
WiFi (not applicable)
Elog (End of Menu)
11.1

Programming the Primary Filtration Menu

During the primary filtration cycle, the pump 1 low speed is activated.
The hot tub is programmed to cycle 4 times (every 6 hours) throughout
the day, each cycle last 2 hours, and a default start time of 12:00 AM, but
this can be changed.
A. Primary Filtration Menu
To change the programmed Primary Filtration Cycle:
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
1. Press until you get to the "PF" Menu. The display will scroll
"PRIMARY FILTER." After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or
system for changes.
3. Press or
switch from "AM" to "PM" you must round a 12-hour period.
to display the current start time and prepare the
to adjust the start time, in 1-hour increments. To
) button you will cycle
Figure 11.0a
J-100
29