Terminal Commands - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

Appendix A: Telnet Commands

Terminal Commands

The Terminal commands listed in the following table can be sent directly to the NXB-KNX via Telnet
terminal session.
In your terminal program, type "Help" or a question mark ("?") and <Enter> to access the Help Menu,
and display the Program port commands described below:
Terminal Commands
Command
----- Help -----
? or Help
DATE
DISK FREE
DNS LIST <D:P:S>
ECHO ON|OFF
GET JAVA HEAP
GET ETHERNET MODE
GET IP
IPSEC ON|OFF|STATUS
52
Description
(Extended diag messages are OFF)
Displays this list of commands.
Displays the current date and day of the week.
Example:
>DATE
10/31/2004 Wed
Displays the total bytes of free space available.
Example:
>DISK FREE
The disk has 2441216 bytes of free space.
Displays the DNS configuration of a specific device including:
• Domain suffix·
• Configured DNS IP Information
Example:
>DNS LIST [0:1:0]
Domain suffix:amx.com
The following DNS IPs are configured
Entry 1-192.168.20.5
Entry 2-12.18.110.8
Entry 3-12.18.110.7
Enables/Disables echo (display) of typed characters.
Display the amount of memory allocated for Java pool.
This is the current Java memory heap size as measured in Mega-
bytes.
Example: a value of 5M = 5 MB.
Displays the current ethernet configuration setting.
Settings are either "auto" in which the ethernet driver will discover it's
settings based on the network it is connected to OR <speed> and
<duplex> where speed is either 10 or 100 and duplex is either full or
half.
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
Note: See SET ETHERNET MODE.
Displays the current IP configuration.
Example:
>GET IP
IP Settings
HostName MLK_INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
Enables/Disables IPSec security or displays current setting.
NXB-KNX Operation/Reference Guide