Ip Settings - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

Knx communications gateway

Hide thumbs Also See for NetLinx Interface NXB-KNX:

Table of Contents

IP Settings

Select IP Settings from the Admin drop-down menu to open the IP Settings page (FIG. 14). Use the options

on the page to specify network/IP settings for this NXB-KNX unit.

FIG. 14

IP Settings page

NXB-KNX Operation/Reference Guide

Hostname:

Enter a Hostname for this unit (enabled only if DHCP is disabled).

DHCP:

Click to toggle DHCP on this unit (default = enabled).

Note that DHCP must be enabled in order for the zero-configuration client (i.e.

Bonjour for Windows) to detect the NXB-KNX on the network.

See the NetLinx Studio v3.0 (featuring Zero-Config functionality) section on

page 5 for details.

IP Address:

Enter an IP Address for this unit (enabled only if DHCP is disabled).

Subnet Mask:

Enter a Subnet Mask for this unit (enabled only if DHCP is disabled).

Gateway:

Enter a Gateway for this unit (enabled only if DHCP is disabled).

Domain Suffix: Enter the Domain Suffix for this unit.

DNS 1, 2, 3:

Enter up to three DNS addresses for this unit.

Reboot:

Click to initiate a system reboot.

IP Settings changes only take effect after a reboot.

Configuration

Table of Contents