Login Information; Logging Into The Configuration Manager (With Security Enabled) - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

Configuration

Login Information

Use this set of options to specify a Username and Password. These will be required only if one or more of the
Security Settings are enabled.

Logging Into the Configuration Manager (With Security Enabled)

Login is only required if the Web and/or Admin security options have been enabled on the unit.
1.
Click the Login link in the upper-right corner of the initial page (FIG. 5). This invokes the Login popup
page (FIG. 13).
FIG. 13 NXB-KNX Configuration Manager - Login popup page
Enter the default login information:
2.
Click the Login button.
Once you have successfully logged into the Configuration Manager, the IP Settings page is displayed, and can
be edited as needed.
10
Username:
New Password:
Confirm Password:
Restore Factory Defaults: Click to restore the login information to the factory defaults:
Click Accept to save your changes. Note that changes on this page take effect immediately.
Click Cancel to cancel any changes.
Username = administrator
Password = password
Enter the Username that will be required to login to this unit if
security is enabled. The default Username is "administrator".
Enter a new password that will be required to login to this unit if
security is enabled. The default Password is "password".
Re-enter the new password in this field.
• Default Username = administrator
• Default Password = password
NXB-KNX Operation/Reference Guide