Accessing The Webconsole Via Web Browser; Admin Menu - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

4.
You can access any device in the Zero-Config list simply by double-clicking on it's entry. The selected
device's WebConsole (HTML) is displayed in a NetLinx Studio window.
5.
The unit's IP Address can be edited IP Settings page (see the IP Settings section on page 11).

Accessing the WebConsole via Web Browser

From any PC that has access to the LAN that the NXB-KNX resides on:
1.
Open a web browser and type the IP Address of the target NXB-KNX unit in the Address Bar.
2.
Press Enter to access the WebConsole for the specified NXB-KNX unit. The initial view is the IP Settings
page (FIG. 5).

Admin Menu

There are several configuration pages included in the Configuration Manager, all of which are accessed via the
Admin drop-down menu (FIG. 9):
FIG. 9 NXB-KNX Configuration Manager -Admin menu
Click on an option in this menu to access each of the configuration pages, as described in the following
sub-sections:
If you see the additional entries: Application Upgrade and Firmware Upgrade in
the Admin menu, it is an indication that your NXB-KNX is currently using an older
version of the device Application and Firmware.
Refer to the One-Time Upgrade of the NXB-KNX to a Native NetLinx Device section
on page 47 for instructions on upgrading your NXB-KNX to the latest NetLinx
Firmware.
Once the unit has been upgraded to the current version of NetLinx Firmware, the
Admin Menu will appear as it is shown in FIG. 9.
NXB-KNX Operation/Reference Guide
Configuration
7