Poe (Power Over Ethernet); Knx Connector - AMX NetLinx Interface NXB-KNX Operation/Reference Manual

Installation

PoE (Power Over Ethernet)

The NXB-KNX uses CAT5/CAT6 wire via the Ethernet port for PoE power.
Use the PS-POE-AF Power over Ethernet Injector (FG423-80) to simplify wiring and installation by
eliminating the need for an AC outlet at each point of installation.
The NXB-KNX can be placed up to approximately 330' (100 meters) from PoE
Injector.

KNX Connector

The KNX connector on the rear panel is a 2-pin captive-wire connector that provides communication between
the NXB-KNX and the KNX control system via 2-wire shielded twisted pair cabling (FIG. 4).
-
FIG. 4 KNX Connector wiring diagram
4
If used with a non PoE-capable Ethernet switch (such as the NXA-ENET24), then an optional PS-
POE-AF Power-over-Ethernet (PoE) power supply is required to provide power to the NXB-KNX.
If the NXB-KNX is used with a PoE-capable Ethernet switch (such as the NXA-ENET24PoE), then
no PoE Injectors are required.
+
2-wire twisted pair
KNX
Control
Bus
NXB-KNX Operation/Reference Guide